Vehicle handbook
Ford Focus Mk3
2011–2018 · Symptoms, fault codes and practical repair explanations
Choose a vehicle system
Problem guides
Showing 1–12 of 40
Rough idle during the first cold-start minute
A rough first cold minute needs a genuine cold-start sample. Ignition, injector behaviour, intake leaks, temperature information and mechanical sealing can overlap; petrol and diesel Focus engines require different diagnostic branches.
Cabin blower works only at some settings
A blower missing some speeds may have a failed speed-control path, overheated connector or excessive motor load. Manual and automatic Focus climate systems can use different control arrangements, so identify the fitted circuit before buying a resistor.
Brakes squeal during light braking
Brake squeal can be caused by pad/disc interaction, contamination, incorrect hardware or wear, but sound alone does not establish brake safety. Light-braking noise should be separated from grinding, pulling or reduced braking before deciding whether it is a comfort complaint or a mechanical fault.
Vibration appears in a particular road-speed range
Vibration in a road-speed band often leads towards wheels or rotating driveline components, but speed alone does not identify the source. Steering-wheel, seat and acceleration-dependent vibration provide different clues and can coexist on a Focus.
Hard starting follows refuelling on a 2.0 petrol Focus
Hard starting immediately after refuelling on an applicable 2.0 petrol Focus can involve unintended purge flow. The association is useful evidence, but normal cranking, fuel delivery and mixture conditions still need checking before a valve is prescribed.
Fuel gauge behaviour changes together with a purge fault
An inaccurate fuel gauge appearing with a purge fault deserves more than a sender replacement. On certain 2.0 petrol Focus applications, abnormal tank vacuum has been associated with tank deformation. That history supports inspection, not a diagnosis for every inaccurate gauge.
Stalling returns after an earlier purge-related repair
Stalling after an earlier purge repair may mean the original hardware defect remains, a consequence was missed or a different cause now exists. The repair invoice is important context, but neither a software update nor a replaced valve proves the complete fuel-vapour system is healthy.
DPS6 shudders during light acceleration from a stop
DPS6 shudder during take-off can involve clutch friction behaviour, contamination, control setup or another powertrain vibration. This branch applies to the identified DPS6 dry dual-clutch gearbox, not every transmission marketed as PowerShift.
Judder returns soon after a clutch replacement
Judder returning soon after a DPS6 clutch replacement calls for a review of both the installation and the original diagnosis. A fresh clutch does not correct a leaking seal, incorrect setup or another source of powertrain vibration.
Oil is visible near the DPS6 clutch housing
Oil near a DPS6 clutch housing needs its source identified before a clutch or seal is condemned. The clutch friction system is dry, but neighbouring engine and gearbox oil boundaries can leak into or around the same area.
DPS6 intermittently loses gear engagement
Intermittent DPS6 loss of engagement can involve electrical supply, communication, actuators or internal mechanical operation. It should be distinguished from ordinary take-off shudder: a car that unexpectedly loses drive needs a different urgency and diagnostic record.
No-crank condition appears with a transmission warning
A no-crank event accompanied by a DPS6 warning can involve start authorization, selected-position information or supply, as well as a transmission-control fault. It must first be distinguished from an engine that cranks normally but will not fire.
Your experience can help another driver
Open a guide to share your checks and repair outcome.
