Oil is visible near the DPS6 clutch housing
Oil near a DPS6 clutch housing needs its source identified before a clutch or seal is condemned. The clutch friction system is dry, but neighbouring engine and gearbox oil boundaries can leak into or around the same area.
Confirm fresh fluid and origin
Record fluid levels and the rate of loss, then clean retained residue safely. Inspect the highest fresh wet point and distinguish engine oil, transmission lubricant and old service spillage. The lowest drip point is not necessarily the source.
Inspect the clutch consequence separately
A transmission workshop should follow the appropriate leak and contamination assessment. External wetness does not automatically establish contaminated friction surfaces, while an apparently dry outside does not exclude an internal leak. Compare the findings with any take-off shudder.
Identify the actual gearbox before applying a seal procedure. A similar-looking Focus transmission may require different parts and access. Do not try to cure friction contamination by adding an additive or changing the wrong fluid.
Repair the boundary before replacing affected parts
Correct the demonstrated leak and assess clutch condition according to the evidence. Replacing friction components while leaving the oil source unresolved risks recurrence. Use the specified lubricant, fill procedure and any required setup after the actual repair.
Outcome & verification
Verify no fresh leakage, stable relevant fluid levels and normal take-off behaviour after comparable use. Keep the identified source and contamination findings in the repair record.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.