Vehicle handbook
Hyundai i30 GD
2012–2017 · Symptoms, fault codes and practical repair explanations
Choose a vehicle system
Problem guides
Showing 1–12 of 40
Engine warning light stays on
An i30 GD engine light can cover ignition, mixture, airflow, boost or emissions faults. Petrol MPI/GDI and CRDi versions do not share one diagnostic path; identify the engine before applying a repair from another i30.
Tyre pressure warning after a temperature change
Colder weather can reduce tyre pressure, but a warning after a temperature change still requires measurement. An actual puncture and a weather-related fall can occur together; visual appearance alone cannot establish safe inflation.
Charging warning while the engine is running
A charging warning on a running i30 concerns generation and delivery of electrical power. Battery age is only one part of the investigation; the alternator drive, cables, earths and control information can create the same broad warning.
ABS warning remains illuminated
An ABS warning on an i30 GD can originate in a wheel signal, electrical supply or another brake-control input. It does not identify a sensor by itself. Braking condition and the complete brake-module code determine the next step.
Starter turns slowly after the car has been parked
Slow cranking after parking can reflect low charge, reduced battery capacity, cable resistance or starter load. It differs from normal-speed cranking without ignition and should not automatically be diagnosed as an overnight drain.
Rough idle during the first cold-start minute
An i30 that runs roughly only during the first cold minute needs testing before it warms up. Petrol ignition/fuelling and CRDi preheating/injection create different branches, and a smooth arrival at the workshop does not rule out the complaint.
Cabin blower works only at some settings
Blower operation at only some settings needs the fitted control arrangement identified. Manual stepped resistance and electronic climate control require different tests; the missing settings do not automatically prove a resistor is the only failed part.
Steering wheel vibrates mainly while braking
Steering-wheel vibration mainly during braking can involve disc/hub geometry, friction variation or suspension movement. Calling every case a warped disc can miss the reason a replacement develops the same symptom again.
Windscreen washers do not spray
Washers that do not spray can involve fluid supply, freezing, blocked outlets, a disconnected hose or an electrical fault. Hearing the pump helps separate branches but does not prove it delivers fluid at the required outlet.
Click is felt under the dash when gently reversing steering direction
A click under the dash when steering direction reverses can originate in a column-mounted assistance assembly, joint or mounting. On an i30 GD, a familiar coupling repair is one candidate, not a diagnosis from sound alone.
Knock occurs on road bumps but not during stationary steering
A knock on bumps without steering movement should not be assigned to an assistance coupling merely because the sound seems near the column. Suspension, rack attachments, joints and body contacts can transmit noise into the cabin.
Steering does not return normally after work
Steering that fails to return normally after work needs prompt mechanical and setup assessment. It is not simply a noise complaint. Binding, alignment changes, incorrect assembly or assistance faults can all affect return, and calibration alone cannot correct a physical obstruction.
Your experience can help another driver
Open a guide to share your checks and repair outcome.
