A replacement lamp still reports a lighting fault
A lighting warning after lamp replacement can involve an incompatible assembly, connection, control setup or a remaining supply fault. The replacement's appearance and plug shape do not prove its electrical or regional compatibility.
Compare original and replacement details
Record part references, equipment and the exact returning code. Note whether the function is visibly wrong or only a diagnostic warning remains. Check whether adapters or aftermarket modules were added.
Verify delivery and expected load
A workshop should inspect connector seating, terminal condition and loaded supply/earth. Check command and any required coding/setup against the actual vehicle. A warning may concern an electrical relationship not corrected by replacing the light-emitting part.
If supply is sound, assess compatibility and the replacement's operation. Do not install arbitrary resistors to simulate a load before determining the cause; they can generate heat and mask a real fault. A new unit can be defective, but it should fail a relevant test before another is ordered.
Confirm every supported mode
Correct the demonstrated circuit, part-selection or configuration issue. Test running-light and associated dimming/headlamp modes applicable to the car, not just one switch state. Inspect disturbed seals and routing before final assembly.
Outcome & verification
Confirm correct visible operation and no renewed relevant fault through the original operating condition, with secure wiring and suitable part identification.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.