Light fault appears after moisture is seen inside the lamp
Moisture and a lighting fault can be related, but light condensation and damaging water ingress are different findings. On a GD lamp, the fault needs electrical evidence and an inspection of sealing, vents and previous repairs.
Record the water pattern
Note whether mist clears, droplets accumulate or water pools. Compare the other side and weather conditions. Save the lighting fault and recent bulb/lamp or body work. A photograph alone cannot establish whether the driver board was damaged.
Inspect entry and circuit consequences
A workshop should inspect covers, vents, seals, cracks and connectors, then test supply/earth and the affected lamp function. Corrosion can remain after visible moisture evaporates. Conversely, moisture seen at one time does not prove every subsequent flicker is internal.
Do not seal designed vents indiscriminately or drill drainage holes without an approved repair basis. Changing ventilation can worsen condensation. Internal electronic repair should account for the actual assembly design and road-lighting requirements.
Repair the cause as well as damage
Correct the demonstrated water path and damaged electrical parts. Drying alone can temporarily restore operation while leaving corrosion and renewed entry. A replacement lamp with an unresolved body or connector water path may fail again.
Outcome & verification
Verify normal illumination and no renewed abnormal water accumulation under comparable conditions. Retain the source found and circuit findings, not just an image of a dried lamp.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.