One running light flickers while the other is steady
One running light flickering while the other stays steady directs attention towards its local supply, connection or lamp electronics. It does not automatically prove an LED board has failed, and the actual GD lamp specification needs identification.
Record the light state
Compare running-light, headlamp and dimming conditions where supported. Note vibration, heat and moisture effects and any recent lamp work. Distinguish a recorded warning from visible flicker; either may exist without the other.
Compare local delivery under load
A workshop should inspect terminals, earth and power/control at the affected unit using the correct diagram. A no-load voltage reading can hide resistance that appears when the lamp draws current. Compare the stable side where appropriate without swapping incompatible units.
If supply and command remain correct during flicker, assess the lamp/driver assembly. LED modules are not universally interchangeable or separately serviceable. Do not bypass a driver with direct battery power, since the LEDs may require regulated current.
Correct the demonstrated defect
Repair wiring or connectors where proven and address any water route. If the assembly is defective, choose the compatible component and required setup. An apparently identical replacement can have different control or regional light behaviour.
Outcome & verification
Confirm steady illumination across the original heat/vibration and operating conditions, with no renewed relevant lighting fault.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.