Regeneration frequency does not improve after filter cleaning
Frequent regeneration after DPF cleaning can mean restriction remains, a measurement fault persists or the engine continues producing excessive soot. A cleaned filter does not automatically validate the sensors, pipes and combustion conditions used to manage it.
Compare before-and-after evidence
Obtain the cleaning result and original loading/pressure information. Confirm which component was cleaned and whether required supported reset/setup was completed. A counter reset changes stored information, not the filter's physical condition.
Recheck pressure and soot-production inputs
A workshop should verify pressure-sensor offset/plausibility, pipe routing and blockage and temperature information under the prescribed conditions. Compare actual flow restriction with the cleaning evidence instead of judging only the dashboard lamp.
If measurement is sound, assess warm-up, injection and air/EGR behaviour for continuing soot production or failed regeneration prerequisites. An apparently low pressure at one idle point does not prove acceptable flow under load. Ash and soot need different treatment and should not be merged into one loading estimate.
Repair the remaining failed relationship
Correct sensing, engine or filter defects demonstrated by testing. Do not repeat cleaning or force regeneration solely because the previous job was a cleaning. Keep the original and current data so partial improvement is visible.
Outcome & verification
Confirm appropriate regeneration completion and subsequent frequency using a comparable driving record, with plausible pressure/temperature data and no renewed relevant fault.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.