AI4Car

Central locking works but the door-open message stays on

Focus Mk3Body & safety
The problem

Central locking can operate while a door-open message remains incorrect. The message may reflect latch feedback, wiring or a genuine closure problem, so physical latch security must be established before treating it as an electrical nuisance.

Compare physical and reported position

Check whether the door retains securely and sits correctly. Record flickering over bumps, interior-light behaviour and recent trim work. A door that opens unexpectedly belongs to the mechanical safety branch, regardless of what the display reports.

Test feedback under the failing condition

A workshop should monitor live door status and inspect the relevant latch circuit using the correct diagram. A signal changing as the harness flexes suggests a different path from feedback that remains wrong with stable wiring and secure closure.

Inspect terminals, moisture and door-jamb conductors. A continuity test at one stationary angle may miss an intermittent break. Do not apply battery voltage to an unknown signal wire or bypass the latch switch to extinguish the message.

Restore the complete function

Repair the demonstrated mechanism, connector or harness defect and address any water-entry source. Recheck courtesy lighting, locking and repeated open/close status. Adjusting the striker is appropriate only when alignment is actually wrong.

Outcome & verification

Confirm accurate status changes alongside secure mechanical closure through repeated operation and a safe controlled harness check.

Do not drive if latch security is uncertain. Keep clear of latch pinch points and follow the correct precautions around restraint wiring.
Discuss this problem ↓

Community discussion

Owner experiences, questions and other possible solutions.

No owner experiences yet. Share what was checked and what happened.

Sign in to share your experience

Helpful votes reflect community experience. Repair outcomes are self-reported.