Engine cranks but does not start
Normal-speed cranking without starting is different from slow cranking or no starter operation. A Focus Mk3 can fail to start because permission, engine-speed information, fuel delivery, ignition or mechanical timing is missing; the engine identity determines the tests.
Capture the non-start before it disappears
Record whether the fault is cold, hot or intermittent and whether a security/key message appears. Save faults and check available cranking speed and synchronization information. Note recent refuelling, battery work or engine repairs.
Compare permission with combustion requirements
A workshop should establish that the controller recognizes a valid start and engine rotation. On petrol versions, assess ignition and fuel delivery; on diesels, investigate the applicable pressure, injection and preheating conditions. Hearing a pump run does not establish correct fuel pressure.
If synchronization is missing or cranking sounds uneven, assess signal integrity and mechanical timing before prolonged attempts. Do not replace a crank sensor simply because engine-speed information is absent without checking its supply, wiring and target.
Verify under the original conditions
Repair the demonstrated authorization, supply, control or mechanical fault. An intermittent successful start is not proof of repair unless the failed input has been identified and corrected. Keep the original scan so later investigation does not restart from assumptions.
Outcome & verification
Confirm reliable starting after the same cold soak or hot parking interval, with appropriate cranking data and no renewed relevant fault.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.