All codes
Power Steering Pressure Sensor Circuit Low Input
P0552 indicates a fault related to power steering pressure sensor circuit low input. Learn the likely causes and a practical diagnostic order before replacing parts.
What you may notice
Symptoms
- 01Warning light may illuminate
- 02System function may be impaired
- 03Symptoms depend on the vehicle and fault conditions
Where to look first
Common causes
- 01A pressure switch fault, fluid or hydraulic problem, or connector damage can cause implausible feedback.
- 02Connector, wiring, ground, or supply-voltage fault
- 03Vehicle-specific mechanical or control problem
A sensible sequence
Best diagnostic order
- 01Record codes and freeze-frame data
- 02Compare power-steering pressure switch state with steering load and inspect wiring and fluid/system condition.
- 03Compare results with vehicle-specific service information
- 04Verify the repair and monitor readiness
Step by step
What to check and repair
- 01Compare power-steering pressure switch state with steering load and inspect wiring and fluid/system condition.
- 02Repair the confirmed cause and retest under the original fault conditions
Read the signals
Live-data clues
Steering pressure switch state
- Typical behavior
- Plausible for the current operating condition and vehicle specification
- Possible clue
- An implausible value or dropout helps localize the fault
| Parameter | Typical behavior | What it can suggest |
|---|---|---|
| Steering pressure switch state | Plausible for the current operating condition and vehicle specification | An implausible value or dropout helps localize the fault |
What P0552 means
P0552 is an OBD2 diagnostic trouble code for power steering pressure sensor circuit low input. The code identifies a detected condition, not a confirmed failed part.
Diagnostic direction
Compare power-steering pressure switch state with steering load and inspect wiring and fluid/system condition.
Before clearing the code
Save stored and pending codes and freeze-frame data. Confirm the exact vehicle procedure and specifications, repair the verified cause, and repeat the applicable test or drive cycle.