Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 2
P0160 means Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 2. Learn the likely symptoms, causes, safety implications, and a practical diagnostic order.
What you may notice
Symptoms
- 01Check Engine light
- 02Failed emissions inspection
- 03Possible rough running or increased fuel use
- 04Often little noticeable drivability change
Where to look first
Common causes
- 01Faulty oxygen sensor or heater
- 02Exhaust leak or damaged sensor wiring
- 03Incorrect mixture affecting sensor response
- 04Connector, fuse, relay, or control-circuit fault
A sensible sequence
Best diagnostic order
- 01Record codes, freeze-frame data, and monitor status
- 02Inspect the exhaust and complete sensor circuit
- 03Verify heater power, ground, and resistance to specification
- 04Compare sensor activity and fuel trims
- 05Complete the proper drive cycle after repair
Step by step
What to check and repair
- 01Inspect exhaust leaks, wiring, connectors, and heater power
- 02Graph oxygen-sensor response and compare banks
- 03Test the heater circuit and sensor signal
- 04Correct mixture or exhaust faults before replacing the sensor
Read the signals
Live-data clues
Oxygen-sensor response
- Typical behavior
- The signal and heater should behave as specified for sensor position and operating mode
- Possible clue
- Slow, fixed, or inactive output can reflect a sensor, circuit, exhaust, or mixture problem
| Parameter | Typical behavior | What it can suggest |
|---|---|---|
| Oxygen-sensor response | The signal and heater should behave as specified for sensor position and operating mode | Slow, fixed, or inactive output can reflect a sensor, circuit, exhaust, or mixture problem |
What P0160 means
P0160 is a generic OBD2 diagnostic trouble code. Its standardized description is “Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 2.” It identifies the circuit or operating condition detected by the control module, but it does not prove that a particular part must be replaced.
Diagnostic direction
Oxygen-sensor codes require checking heater power, wiring, exhaust leaks, and mixture control. Sensor position and vehicle strategy determine the expected waveform.
Before clearing the code
Save all stored and pending codes, freeze-frame data, and related module faults. Use vehicle-specific service information because connector locations, expected values, enable conditions, and repair procedures vary by make, model, engine, and year. Repair the verified cause before clearing the code, then repeat the appropriate self-test or drive cycle.