AI4Car

Petrol engine misfires under load but idles normally

Polo V (6R)Engine & ignitionP0300
The problem

A Polo V petrol engine can run smoothly at idle yet misfire when cylinder pressure rises during acceleration. Ignition insulation, fuel delivery and cylinder sealing need different tests. Identify the exact engine before selecting plugs, coils or a procedure from another Polo generation. This is distinct from a timing-drive rattle or clutch judder.

Capture the loaded cylinder pattern

Record engine speed, gear, temperature and whether the malfunction lamp flashes. Save pending faults, cylinder activity and freeze-frame information before clearing. Note recent plug work, fuel changes and whether the event depends on damp weather. A generic description of shaking is insufficient: compare engine misfire evidence with wheel-speed or clutch vibration before deciding which system is responsible.

Test ignition before guessing at expensive fuel parts

A workshop should inspect correct plug specification/condition, coil boots, connections and evidence of tracking, using the applicable loaded assessment. A permissible controlled substitution can support an ignition diagnosis when the event follows the component. If it stays with the cylinder, investigate injector delivery and mechanical sealing. A fault affecting several cylinders under demand may require fuel-supply or air-control checks rather than a set of coils. Normal idle fuel pressure cannot establish adequate delivery under load.

Repair the failed path and repeat its demand

Replace or repair the demonstrated ignition, fuel, air or mechanical defect and check the reason for repeat fouling if present. Do not increase plug gaps, fit a random coil revision or erase counters as a cure. Retain the failing data and verify under the original safe operating conditions, because a smooth warm idle does not reproduce the pressure that exposed the weakness.

Outcome & verification

Confirm stable cylinder contribution during comparable controlled acceleration and no renewed misfire or relevant mixture fault. Keep any separate clutch or wheel-speed vibration open rather than assuming the ignition repair must remove it.

Stop for severe shaking, a flashing malfunction lamp, fuel leakage or abnormal mechanical noise. Do not repeatedly use full throttle to demonstrate an active misfire.
Discuss this problem ↓

Community discussion

Owner experiences, questions and other possible solutions.

No owner experiences yet. Share what was checked and what happened.

Sign in to share your experience

Helpful votes reflect community experience. Repair outcomes are self-reported.