Lean correction at light load: distinguish a small air leak from a purge-flow problem
The petrol engine feels uneven at light throttle and fuel correction is positive, while stronger acceleration may feel more normal. This pattern can be consistent with a relatively small extra air path, but fuel correction is a control response rather than the location of a fault.
Check what the measured values actually mean
Confirm the engine and whether the displayed item is live correction, learned adaptation or another lambda-related value. Generic scan labels are not always equivalent to the manufacturer's definitions. Compare data only under appropriate closed-loop operating conditions and note engine temperature, load and purge state.
A positive correction means the controller is adding fuel relative to its base calculation. It does not automatically mean that an oxygen sensor is defective, nor can a single snapshot establish a leak. Recent code clearing can also remove learned values that would otherwise show the pattern.
Compare operating conditions rather than chasing a number
Record a stable idle and another controlled operating condition. A leak that contributes a similar amount of extra air can have a larger relative influence when total airflow is low. If the discrepancy grows under load instead, fuel supply, air measurement or another cause may deserve greater priority.
Have the intake and ventilation paths inspected/tested, then assess purge operation where the fitted system allows a meaningful controlled comparison. If mixture response changes when an unintended purge path is isolated by the workshop, test the valve's sealing and line routing. A correlation with commanded purge alone can also reflect normal control activity and needs interpretation.
Where air-path tests pass, compare fuel-pressure tracking and sensor plausibility using the correct engine diagnostic information. Do not replace all mixture-related sensors because the trim is away from zero.
Keep alternatives open until the fault is demonstrated
Repair a confirmed intake/ventilation leak, a failed purge component or a demonstrated fuel/signal fault. The light-load pattern helps prioritise tests; it does not make the EVAP valve the presumed answer.
If a repair changes idle correction but light-load hesitation remains, log the remaining event separately. It may involve ignition or another transient condition rather than the same mixture fault. A different driving style can hide hesitation without establishing a repair.
Outcome & verification
Compare the same stable operating points and the original light-load event after repair, with learned data allowed to become meaningful again. Verify the implicated circuit's own test as well as the subjective improvement.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.