Misfire remains after ignition checks: decide whether the fault is shared or cylinder-specific
Plugs and coils have been inspected or replaced, but the petrol TSI still misfires. The next useful distinction is whether one cylinder stays affected or several cylinders respond to a common air/fuel condition. Another set of ignition parts is not a diagnostic step on its own.
Establish what the previous ignition check proved
Record which parts were tested, whether a controlled coil comparison was made and what happened to the cylinder counters. A new part is not proof of a sound installation, while a visual inspection is not the same as testing under the condition that produces the fault.
Identify the engine and capture the original operating state: cold start, warm idle or load. If the fault is cold-only, a warm compression or idle check may answer a different question. Preserve the scan before clearing accumulated evidence.
Use the cylinder pattern to select the next test
For repeated misfire on one cylinder, investigate that cylinder's plug condition, injector/circuit and mechanical sealing. A workshop can choose compression, leak-down or injector tests according to the observed pattern. High-pressure direct-injection work requires the proper depressurisation, sealing and installation procedures.
For misfires spread across cylinders, compare mixture correction, intake integrity, crankcase-pressure regulation and fuel supply. A shared leak or pressure problem can affect more than one cylinder; it should be demonstrated rather than inferred simply because several counters rise.
- Fault stays at one cylinder despite a controlled coil comparison: stop buying coils and test what stayed with that cylinder.
- Fault varies with a shared mixture condition: test air/fuel influences before treating every cylinder as a separate failure.
- Counters remain quiet but the car vibrates: reconsider whether the perceived roughness is combustion-related.
Keep the repair decision separate from the symptom label
A failed ventilation assembly is only one possible explanation in this entry, not the default answer. Intake deposits, injector behaviour and cylinder condition require their own evidence, and several faults can coexist.
Ask the workshop which measurement failed and which result after repair should change. If replacing a component only reduces the symptom, compare the remaining pattern instead of declaring a complete cure. Make one evidence-led change at a time where practical so the effect remains interpretable.
Outcome & verification
Reproduce the original cold/warm/load condition with safe workshop methods. Compare the same cylinder counts and relevant mixture or mechanical findings after repair. An engine that sounds smoother for a minute is encouraging but not a substitute for the original failed check passing.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.