Misfire moves with a coil: when the comparison supports a coil repair
A petrol engine repeatedly misfires on one cylinder, and the fault appears at another cylinder after a coil is moved. That is strong localisation evidence when the comparison is controlled. It becomes less conclusive if plugs, connectors and several coils were moved at the same time.
Keep the original cylinder map
Save the initial codes and current misfire counters, identifying cylinders using the engine's actual numbering. Record the conditions that reproduce the fault. An old stored P0301 is not evidence that cylinder 1 is still misfiring after the comparison.
Confirm that the coils are interchangeable for the exact engine and inspect for contamination, damaged boots or an incompletely engaged connector. Moving ignition components should be done with the engine off and using the correct access/installation procedure; disconnecting coils on a running engine is not a suitable comparison.
Change one variable and interpret the result
If only the suspect coil is moved and a current misfire follows it under the same conditions, the coil/boot assembly becomes the priority. A connector or lead that remained with the original cylinder did not move, so a clear migration helps distinguish those branches.
If the fault stays at the original cylinder, a coil replacement is not supported by that comparison. Inspect its plug and circuit and consider injector or mechanical tests according to the evidence. If both cylinders now misfire, check installation and whether a second fault or unsuitable comparison condition has complicated the result.
A misfire that happens only under load may not appear during a stationary idle check. Conversely, a test after the engine has warmed cannot conclusively localise a fault that only occurs after an overnight cold soak.
Do not lose the reason the component failed
Repair the demonstrated ignition fault and inspect any oil/water contamination, damaged plug or connection that could contribute to recurrence. Replacing a coil while leaving a wet plug well or compromised boot path may produce only a temporary result.
Replacing the entire set is a separate maintenance/cost decision, not something established by one migrated fault. Explain which component failed and why additional parts are or are not proposed. If roughness remains, re-map the current cylinders instead of assuming that every later event is the same failed coil.
Outcome & verification
Confirm the originally affected and comparison cylinders remain free of repeat misfire under the original conditions. Retain the before/after map and check any contamination source. Clearing the stored cylinder codes without observing current behaviour does not complete the comparison.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.