AI4Car

Hybrid will not enter READY after standing

Yaris XP130Electrical & hybrid control
The problem

On a Yaris XP130 Hybrid, illuminated dashboard lights do not establish that the 12-volt supply can complete start-up. A weak auxiliary battery, a start authorisation problem and a genuine hybrid-system fault can all prevent READY. This guide does not apply the hybrid procedure to a conventional petrol Yaris.

Separate no READY from a silent running engine

Check the READY indicator rather than listening for engine noise: the petrol engine need not run continuously when the hybrid system is ready. Note dimming, repeated relay noises, key messages and how long the car stood. Verify the normal start sequence and brake-pedal input without repeatedly cycling the power switch. Record any recent auxiliary-battery replacement or accessory installation.

Test the low-voltage foundation before the traction battery

A workshop should load-test the auxiliary battery and measure supply at the relevant connections during the failed start attempt. Healthy-looking resting voltage is insufficient if a terminal or battery collapses under load. If supply is sound, read hybrid, immobiliser and brake/start-authorisation information together. A generic engine scan may show no fault even though another controller is withholding start permission.

Repair the demonstrated supply or authorisation fault

Correct a weak battery, poor connection or measured authorisation defect using the specified procedures. If the auxiliary battery repeatedly discharges, investigate charging and parked consumption rather than replacing it again. A successful jump-start supports a low-voltage investigation but does not prove the battery itself was the only cause. Genuine hybrid faults require the appropriate diagnostic path, not repeated battery disconnection.

Outcome & verification

Confirm reliable READY entry after a comparable parked period and correct auxiliary charging when ready. Retain controller information for any recurring event; one assisted start is recovery rather than a completed diagnosis.

Follow the exact handbook jump-start connection and polarity instructions. Do not open high-voltage components or touch orange cables. Once READY is illuminated the car can move even with its engine silent.
Discuss this problem ↓

Community discussion

Owner experiences, questions and other possible solutions.

No owner experiences yet. Share what was checked and what happened.

Sign in to share your experience

Helpful votes reflect community experience. Repair outcomes are self-reported.