Judder remains after an adaptation reset
Judder remaining after a DSG adaptation means the original cause needs reassessment. Learning changes control information; it cannot repair worn friction material, contamination, a supply fault or an unrelated engine vibration.
Verify the routine and symptom
Record gearbox identity, prerequisites, completion result and software/part history. Compare the same cold/warm engagement conditions. A started or aborted routine is not a successful setup, and a changed feel is not automatically resolution.
Compare mechanical response and supporting inputs
A workshop should assess appropriate clutch/actuator behaviour and inspect engine smoothness and mounting isolation. If friction or contamination is suspected, establish the evidence and source. A dry/wet design difference changes the diagnostic and repair requirements.
Check supply and relevant faults before another routine. A new circuit fault after work may be separate from the old judder. Do not keep clearing adaptations until a brief improvement appears or use another gearbox's learned-value thresholds.
Choose further work from findings
Correct the demonstrated setup, electrical, engine or mechanical problem. Major clutch/gearbox work should have a failed check supporting it, not simply follow an unsuccessful reset. Retain the routine result and partial changes so later diagnosis does not repeat the same assumption.
Outcome & verification
Verify the original safe hot/cold take-off condition, appropriate control response and no renewed relevant fault. A short improvement after resetting remains provisional.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.