A new wheel sensor does not clear an intermittent signal fault
An intermittent wheel signal remaining after sensor replacement needs the target, installation and circuit reassessed. A new sensor addresses only one component and can be wrong or incorrectly seated without being intrinsically defective.
Compare the old and new fault
Save exact brake-controller records and original dropout conditions. Verify replacement reference and sensor seating. An electrical code immediately after installation differs from an intermittent low-speed plausibility fault.
Test the complete signal path
A workshop should inspect wiring under relevant movement, terminals and the encoder/bearing arrangement. A conductor can pass stationary continuity but interrupt as the suspension moves. Corrosion or debris at the mounting can affect the intended sensor relationship.
Compare supported live speeds and signal quality using the fitted sensor's procedure. Do not apply battery voltage to an unknown signal circuit or assume resistance checks validate an active sensor. If the target is damaged, another sensor will not resolve it.
Select the next correction from evidence
Repair the demonstrated wiring, fitment, target or compatibility defect. Controller replacement requires its own isolated test, not merely the fact that a sensor has already been changed. Retain partial improvements and any unreplicated condition explicitly.
Outcome & verification
Verify stable wheel-speed information through the original safe trigger and no renewed relevant fault after assessment, with appropriate braking checks.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.