Key detection changes after an accessory was fitted
Key detection changing after an accessory installation raises the possibility of interference, altered power or disturbed wiring. Timing is a useful lead, but does not prove the accessory's radio signal is the only cause.
Compare controlled accessory states
Record device type, wiring and exact failing function. Test both keys under similar conditions and compare a safely disconnected accessory where its instructions allow. Do not alter several systems at once or remove protection to create a clearer comparison.
Separate interference from electrical disturbance
An installer/workshop should inspect supply, earth, routing and relevant access-system faults. A permanent-power installation can also deplete the battery, producing recognition problems later rather than immediate interference. A cable routed near detection wiring can introduce another issue.
Use authoritative vehicle and device information for any isolation test. Do not splice into unknown safety/access circuits or replace antennas before the failed condition is isolated. A device switched off through its interface may still remain electrically active.
Restore a supported installation
Correct the demonstrated power, routing, compatibility or device fault, then verify normal key operation and parked energy behaviour where relevant. A relocated device is not a complete repair if its wiring still prevents sleep or strains a connector.
Outcome & verification
Confirm repeatable recognition with the accessory in its normal supported state, both keys checked and no renewed related fault or discharge pattern.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.