No cold air is produced but cabin fan speed is normal
Normal cabin fan speed with no cold air narrows the complaint towards refrigeration or mixing, but does not identify the compressor. The fitted J11 system may regulate output differently from a familiar clutch-controlled design.
Define what fails
Record ambient/vent temperature, idle versus road behaviour and whether cooling ever returns. Read relevant climate/engine faults. Distinguish actual warm air from progressive loss of volume, which requires an air-path investigation too.
Compare command, charge and thermal response
An A/C workshop should establish correct refrigerant condition/quantity and compare pressure/temperature behaviour with the cooling request. A single gauge value or pulley movement is incomplete evidence. Inspect condenser airflow and fan response alongside compressor control.
If the refrigerating side is functioning, test air blending rather than replacing more circuit components. A sensor or control fault can prevent a request, while a mechanically weak compressor may receive a valid command without delivering. Those need different repairs.
Verify sustained operation
Correct the demonstrated leak, airflow, control or mechanical defect using the proper service procedure. A reset or recharge may temporarily change behaviour without proving the cause. Test long enough to reproduce the original heat-dependent condition where relevant.
Outcome & verification
Confirm suitable vent cooling and normal airflow through the original operating state, with any leak follow-up documented separately.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.