AI4Car

Wipers leave persistent streaks

Ceed JDVisibility
The problem

Persistent wiper streaks can come from contaminated glass, damaged blades, incorrect fitment or uneven arm pressure. Replacing blades alone may not help if the glass carries film or the mechanism does not sweep correctly.

Observe the pattern on a wet screen

Record which part of the sweep smears, skips or leaves an unwiped band. Check blade attachment and suitable washer fluid. Avoid operating on dry, icy or heavily contaminated glass, which can damage both blade and screen.

Separate surface contamination from contact

Clean the glass and blades with compatible methods, inspecting for damage and trapped grit. If streaking remains at the same section, a workshop should assess correct blade specification, arm geometry and sweep/contact. Do not bend an arm by guesswork to increase pressure.

A poor spray pattern can leave sections insufficiently wet and imitate blade failure. Check washer coverage and linkage security where motion is abnormal. Abrasive treatments or unsuitable chemicals can damage coatings and rubber instead of removing the cause.

Verify visibility in realistic conditions

Replace damaged or incompatible blades and repair demonstrated arm, washer or linkage faults. Test with adequate wetting through the full sweep. A clean stationary patch does not prove the system clears spray while driving.

Outcome & verification

Confirm a clear sweep, suitable spray distribution and secure blade retention without skipping or abnormal noise. Document remaining glass damage if that limits the result.

Do not drive when visibility cannot be maintained. Keep fingers clear of the mechanism and never release an unprotected spring-loaded arm onto the glass.
Discuss this problem ↓

Community discussion

Owner experiences, questions and other possible solutions.

No owner experiences yet. Share what was checked and what happened.

Sign in to share your experience

Helpful votes reflect community experience. Repair outcomes are self-reported.