Fuel-pressure code returns after a pump replacement
A fuel-pressure code returning after pump replacement means the whole delivery and measurement path needs review. The code describes an unmet pressure relationship, not a guarantee that the replacement pump is defective too.
Compare the original and current event
Save requested/actual pressure, temperature/load and complete codes. Verify the installed part against the engine and record which pump was changed. Low-pressure supply and high-pressure generation are separate functions; a repair to one does not establish the other.
Test supply, command and measurement
A workshop should assess upstream delivery, pump control and rail-sensor plausibility using the correct pressure-safe procedure. A restriction, poor electrical connection or incorrect sensor information can leave the same broad fault after a new pump.
Inspect recent connections, line routing and installation. If pressure falls under demand, compare the sequence with ignition and boost behaviour rather than assume one snapshot proves the root cause. Internal leakage or mechanical drive issues require evidence appropriate to the actual engine.
Require a failed test for further parts
Correct the demonstrated supply, control, sensing or installation defect. Replacing another pump without those checks risks another unchanged result. Do not reset adaptations repeatedly or use unapproved pressure values from a different T-GDi as the reference.
Outcome & verification
Verify requested-versus-actual delivery under the original condition and confirm no renewed fault after evaluation, with a proper fuel-leak check after relevant work.
Community discussion
Owner experiences, questions and other possible solutions.
No owner experiences yet. Share what was checked and what happened.
Sign in to share your experienceHelpful votes reflect community experience. Repair outcomes are self-reported.