AI4Car

One cylinder stays weak after ignition swaps: investigate fuel and mechanical sealing

A4 B8Engine & fuelling
The problem

A misfire that remains on the same cylinder after controlled ignition-component swaps directs attention beyond those parts. It does not immediately prove a bad injector or burnt valve. Wiring, injector operation, local air entry and mechanical condition need to be separated.

Confirm that the swap was informative

Record which coil or plug moved, where it went and whether the misfire stayed with the original cylinder under the same cold condition. A warm test that does not reproduce the complaint cannot validate the swap. Check plug type, condition and connector security.

Save the full fault record and cylinder counts. A broad random-misfire code can coexist with one cylinder contributing most of the disturbance.

Compare electrical, fuel and compression evidence

A workshop should inspect the affected circuit and test injector control, sealing or delivery as appropriate to the engine. Direct-injection components require the correct high-pressure procedures and may have specific installation or setup requirements. Do not casually exchange injectors as though they were coils.

Assess compression and leak-down where indicated, with attention to whether the fault is cold-dependent. The result can help distinguish valve sealing, cylinder condition and other mechanical problems. Intake-valve deposits should be assessed as a possible contributor, not used to bypass these measurements.

Select the repair that follows the failed test

Repair wiring, injector, local sealing or mechanical defects demonstrated by the investigation. Replacing every coil again will not address a cylinder that remained weak through a valid swap. If tests are inconclusive, retain that uncertainty rather than invent an owner-confirmed repair outcome.

Outcome & verification

Repeat the same cold-start check and confirm balanced cylinder contribution without renewed misfire. A smooth warm engine or cleared memory alone does not verify a cold cylinder-specific repair.

Stop for severe misfire, fuel leakage or a flashing warning. High-pressure fuel and compression testing should be performed with appropriate workshop equipment.
Discuss this problem ↓

Community discussion

Owner experiences, questions and other possible solutions.

No owner experiences yet. Share what was checked and what happened.

Sign in to share your experience

Helpful votes reflect community experience. Repair outcomes are self-reported.

One cylinder stays weak after ignition swaps: investigate fuel and mechanical sealing — Audi A4 B8 | AI4Car